Cemix® Mortarflex Plus is a highly concentrated powder that will plasticise, increase open time, retain water, help prevent efflorescence, shrinking and cracking, reduce water absorption and increase bond and strength. Cemix® Mortarflex Plus will improve workability, giving a fattier mix and without the necessity of rewetting. Can be used with all coloured mortar including black oxide. Low cost per mix. Do not use with lime. If lime is required in mix, use Cemix® Cemplus Plasticisers
Typical Application / Uses:
Cemix® Mortarflex Plus is used as an additive in brick and block laying and plaster work.
- Improves workability.
- Increases open time.
- Retains water.
- Helps prevent efflorescence, shrinkage and cracking.
- Cost effective.
- Gives a fattier mix without the necessity of rewetting.
200gms, 600gms, 1.5kg, 3.0kg, 6.0kg & 13kg
Cemix® Mortarflex Plus is ideally added to the bowl during mixing. Shake container thoroughly before use. Use 3 level measuring caps (12gm per cap) per 40kg bag of cement (measuring cap provided in container). Amount of plasticiser required may vary with the type of sand used, however it is important not to overdose or over mix. As MORTAFLEX PLUS acts as a water reducer you may require less water to achieve a workable mix. DO NOT over mix, a maximum of 3 minutes is suggested for most sands. As a guide the following mortar formula is provided as a starting point. Mix 6 - 7 parts by volume of good clean sand to 2 parts ordinary cement. Add Cemix® Mortarflex Plus as per instructions. Mix with clean water to desired consistency. Shake well before use.
Cemix® Mortarflex Plus is ideally added to the bowl during mixing.
Agitate product well prior to use.
Appearance – off white powder
Application Temp –5oc -30oc
Yield / Coverage - 200gms plastic jar will plasticise 5 bags of cement , 600gms Plastic Jar 15 bags, 1.5kg Plastic Jar 37 bags, 3.0kg Plastic Jar 75 bags, 6.0kg Plastic jar 150 bags.
The data shown above reflects typical results based on laboratory testing under controlled conditions. Reasonable variations may occur on site.
Do not use with lime. If lime is required in mix, use Cemix® Cemplus Plasticisers
Store in dry place, out of direct heat and sunlinght.
Clean all tools with water & brush immediately after use.
It is important not to over mix or over dose the product. Please refer to mixing for full instructions.